The new DJI Mavic Pro has revolutionized the drone industry. Up until now, the Phantom-class drone was as portable as you could get for good 4K Video and 12MP stills. The Mavic Pro changes this. Today we get to Unbox the Mavic Pro.
Mavic Pro retail box
First peak of the Mavic Pro
Manuals and four (two for the front arms and two spares) propellers under foam packaging
Cables and propeller bags removed from the retail box
Everything laid out
Top of the Mavic Pro drone without the front propellers installed
Bottom of the Mavic Pro with gimbal cover and silicone protector still on.
Right side of Mavic Pro
Left side of Mavic
Front arms extended into the flying position
Rear arms in process of being folded out. This is about half-way unfolded to the flying configuration.
Bottom of Mavic in unfolded flying configuration
Top of Mavic in unfolded configuration.
Mavic with front propellers and spare propellers laid out
Front propellers matched up with color coded motor hub. Note the motor on the left side of the picture has 3 white stripes on the edge of the motors’ cans. The propeller with the white circle in the middle of the propeller hub goes on the motor with the white markings. The opposite motor seen on the right side of the photo, without stripes receives a matching propeller without any markings.
Striped motor with matching propeller
Propeller placed on top of the spring loaded motor shaft.
You install the propellers by pushing down with a little force to compress the spring, then rotate until the propeller doesn’t spin further onto the motor. Releasing the propeller will lock it in place. If the propeller pops back up, twist the propeller into the other direction after pushing down on it.
Other motor without white markings
Mavic Pro with all four propellers installed
Mavic with propellers unfolded. It literally can not get larger than this :)
Gimbal cover without the silicone cap
Close up of the gimbal, camera and gimbal cover. You can also see the front obstacle avoidance sensors.
Left front arm of the Mavic with the Arm LED visible on the tip of the arm.
Removal of the gimbal clamp and gimbal protector
Gimbal protector being removed
Gimbal without gimbal cover.
Mavic Pro GL200A remote control
Rear view of the Mavic transmitter/remote control
remote control unfolded to accept smartphone or tablet.
Rear of the remote control
The lightning cable is installed by default for iOS devices, but a microUSB and USB-C cable are also included with the Mavic for Android devices.
The bottom of the remote control. Note the Fullsize USB port for attaching larger Tablets with normal USB cables.
Front of the remote control
Left side of the remote control featuring the included cable.
Right side of the remote control with the Sport Mode switch.
Powering on the remote shows a shipping charge of 41%.
microUSB charging cable, spare remote control cables. Also the Mavic Pro charger, note the USB ports allowing for simultaneous remote control and smartphone charging.
10 pin Charger cable
Manuals and DJI Care Refresh card.
Stay tuned for the Unboxing of the Fly More Package Accessories.